Product Categories
Take the sample of at least 3 metres in length, which placed under reference tension, were measured.
Uses its jaws wide enough to accommodate more than two units of core Vernier caliper, measure the diameter of the fiber core under tension, respectively, in the sample of both ends and on three points on the Middle, click the vertical position of each measurement twice.
The measurement results calculated according to the average of six times, in millimeters, accurate to 0.1 mm, as measured the diameter of the fiber core.
Six measurements shall not exceed the difference between any two values of nominal diameter 5%.
These measurements. applies only to twisted rope cores, does not apply to out of the steel wire rope core.
Previous: Test methods for stainless steel wire dimensions and determine the
Next: Wire rope selection
Related Industry Knowledge
- Rotary drilling rigs in use of wire...
- Model selection of wire rope for mi...
- Steel wire rope during use matters ...
- Advantages of forging steel wire ro...
- Technical requirements of the elect...
- Wire rope rigging sorting and proce...
- Beginner how to purchase all kinds ...
- Why don't optimization of wire rope...
- Wire rope selection
- Test methods for stainless steel wi...
- Galvanized Steel Wire Rope Clip Type A
- Wire Rope Clip, Made of Steel
- Us Type Carbon Steel Malleable Wire...
- Galvanized Steel Wire Rope Clips DI...
- Stainless Steel Drop Forged Wire Ro...
- Carbon Steel Drop Forged Us Wire Ro...
- Steel Wire Rope, DIN3055,6x7 FC IWR...
- 6X37+FC/IWS/IWR point contacted ste...
- Galvanized and ungalvanized steel w...